diff -r 8960bfa02f63 -r 1e220602b7a7 pitlane/main.c
--- a/pitlane/main.c	Fri Dec 09 22:02:34 2011 +0100
+++ b/pitlane/main.c	Fri Dec 09 22:15:50 2011 +0100
@@ -31,6 +31,12 @@
 #define PIT_CONNECT_PIN PC3
 #define PIT_GROUND_PIN  PC2 // low active
 
+#define SENS2_PORT      PORTD
+#define SENS2_PIN       PD5
+
+#define LED_PORT        PORTB
+#define LED_PIN         PB5
+
 // internal analog comparator doesnt work well
 //#define ANALOG_COMPARATOR       1
 
@@ -209,6 +215,8 @@
 
 int main(void)
 {
+    uint8_t tmp;
+
     // setup data bit timer2
     TCCR2 = (1<<CS21) | (1<<WGM21); //divide by 8, set compare match
     OCR2 = TIMER2_50US;
@@ -253,6 +261,10 @@
     // setup pitlane output
     DDR(PIT_PORT) |= _BV(PIT_CONNECT_PIN) | _BV(PIT_GROUND_PIN);
 
+    // setup LED
+    DDR(LED_PORT) |= _BV(LED_PIN);
+    LED_PORT |= _BV(LED_PIN); // switch LED off
+
     // CONNECT PITLANE TO MAIN TRACK
     PIT_PORT &= ~_BV(PIT_CONNECT_PIN);
     PIT_PORT |= _BV(PIT_GROUND_PIN);
@@ -324,6 +336,12 @@
             }
         } sens[1].car = 0;
 
+        if ( (PIN(SENS2_PORT) & _BV(SENS2_PIN)) != 0 ) {
+                // set inside status
+                for (tmp=0; tmp<MAX_SLOTS; tmp++)
+                    slot[tmp].inside = 0;
+                RS232_puts_p(PSTR("PIT:EXIT\n"));
+        }
 
         if (sens[2].car != sens[2].state) {
             sens[2].state = sens[2].car;
@@ -340,6 +358,11 @@
             }
         } sens[2].car = 0;
 
+        // enable LED when car is in pitlane
+        LED_PORT |= _BV(LED_PIN);
+        for (tmp=0; tmp<MAX_SLOTS; tmp++)
+            if (slot[tmp].inside) LED_PORT &= ~_BV(LED_PIN);
+
 
     } // main loop end
 };