sanguino/firmwares/arduino-usbserial/readme.txt@770b218a4931 (annotated)
sanguino/firmwares/arduino-usbserial/readme.txt
Fri, 17 Nov 2017 10:13:31 +0100
- author
- mdd
- date
- Fri, 17 Nov 2017 10:13:31 +0100
- changeset 3
- 770b218a4931
- parent 2
- b373b0288715
- permissions
- -rw-r--r--
proper configuration, homing and planner optimization
| 2 | 1 | To setup the project and upload the Arduino usbserial application firmware to an ATMEGA8U2 using the Arduino USB DFU bootloader: |
| 2 | 1. unpack the source into LUFA's Projects directory | |
| 3 | 2. set ARDUINO_MODEL_PID in the makefile as appropriate | |
| 4 | 3. do "make clean; make" | |
| 5 | 4. put the 8U2 into USB DFU mode: | |
| 6 | 4.a. assert and hold the 8U2's RESET line | |
| 7 | 4.b. assert and hold the 8U2's HWB line | |
| 8 | 4.c. release the 8U2's RESET line | |
| 9 | 4.d. release the 8U2's HWB line | |
| 10 | 5. confirm that the board enumerates as either "Arduino Uno DFU" or "Arduino Mega 2560 DFU" | |
| 11 | 6. do "make dfu" (OS X or Linux - dfu-programmer must be installed first) or "make flip" (Windows - Flip must be installed first) | |
| 12 | ||
| 13 | Check that the board enumerates as either "Arduino Uno" or "Arduino Mega 2560". Test by uploading a new Arduino sketch from the Arduino IDE. |
